Utilisateur

It seems my original post was lost.

I have an evo-all configured with a compustar cm7200s + drone. Everything works as expected except the following.

- Doors will not lock/unlock with Compustar remote is the vehicle is remote started / Subaru remote works

- Auto lock on ignition or tach does not work if remote started

I have checked all wires as instructed and they are all correct.

Currently the Lt Blue & White/Red (A20 & D6) are connected to the connector side of the cut door lock data wire and the White/Green (D4) is connected to the other side of the cut wire.

When connecting the Data Link cable from the remote start to the EVO-ALL all three LEDs flash 25 times.

While debugging a door lock problem on a 2013 Subaru Crosstrek I did a master reset on the EVO-ALL, set the C1 option as directed and when connecting the EVO-ALL data link cable all three LEDs began flashing.

This is the second unit that this has happened with the same exact scenario. The first unit also had a bad data link connector causing intermittent power but after receiving the new unit and installing with the same lock problem I reset it and experienced the same exact problem.

Re-Flashing the unit with any version of firmware has no effect. Same problem. Both units communicated with the Flash programmer without any problems only when connected to the remote start do I see the problem.

I would have thought it was the cable but... The new unit worked perfectly with the same cable until I reset the unit.

Help please.

------update 12/14/15

Two things. When I say three LEDs are flashing I mean all 3 are flashing at the same time not sequentially. On the first unit I tried reprogramming the key but this was not successful but I don't remember the exact problem. 

After reset and connecting with the Flashlink2 I can see that the key bypass is still there and active. Are you saying that I need to run the decrypter programming sequence again?

At the moment the Evo-All will not talk to the compustar at all except to pass signals through. 

Thank you