I have a 2014 Ford Edge, I purchased the EVO-Fort1.
I followed the manual:
https://fortin.ca/download/34421/evo-all_ig_tsa_bi_for1-80bits_c_34421.pdf
for installation.
I installed the T-Harness, car starts with no issue so Im sure thats installed correctly.
I then made wire connections for A19, A5 (door lock and unlock) and C3,C4 (Can Hi and lo)
I have two keys stamped SA. I hold the button as in the manual til I see the blue and red leds (programming mode) and follow the steps for the keys, insert key 1, turn to run, wait 3 seconds, turn key off, insert key 2 and turn to run for 3 seconds turn off and reinsert key 1 and turn to run.
At this point I expect the EVO to do a lot of blinking, but nothing happens, it sets on the Blue and Red leds.
What have I failed to do?
Service number: 001 A06 683665
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
