Hi
I am attempting to install an EVO-ALL stand alone remote starter on a Toyota RAV4 Hybrid (2016, push-to-start). Until I got to the 30-pin connector the installation proceeded smoothly as described in this guide: http://fortin.ca/en/download/58691/58691.pdf
As you can see from my attached photos the wires on the 30-pin connector in question look different than the one pictured in the guide downloaded from fortin.ca ('58691.pdf'). A couple of wires do not exist in my vehicle (among others: blue and red wires for tapping into RX and TX respectively).
Do you have any recommendations on how I can continue and complete the installation?
Thanks.
Link to previously attached photos: https://jimlarsen.ocloud.de/index.php/s/HrIMS9quD2v6ewg
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
