English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

05/09/2016

 Toyota James G. (340Pts.)

1

Horn blowing constantly when Evo-All data link is disconnected

Installed an Evo-All + Prestige APS-57E system on a 2015 Corolla S. I also enabled the Evo-Alarm function. Everything works perfectly. But I accidently noticed what I believe could be a bad unit issue...

 

If I disconnect the datalink connector of the Evo-All, the horn constanly blows.

 

I even disconnected ALL connectors from the Evo-All and connected just the Evo-All by itself to the 20-pin harness and the horn started blowing again?? I have never seen this happen before and am worried that if the vehicles battery was ever disconnected, the client's horn would just start blowing? 

 

Somehow, the Evo-All has an internal ground signal inside itself? I tried reseting it as well. I also disconneted the horn connector from the steering wheel column and the Evo-All would still send a ground signal to the horn wire and blow it.

 

Conencting the data-link conector stops this from happening the the Evo works fine again. Is this just a bad unit?

Connectez-vous pour répondre Voir 2 réponse(s)

05/09/2016

 Toyota James G. (340Pts.)

0

Evo-All reseting itself -- and options

This is the same vehicle -- 2015 Corolla S. I have an Evo-All + Prestige APS-57E. Recently the client took the vehicle to the dealer and the battery was disconnected. After which the remote start no longer worked. I took a look under the dash and the Evo-All's red LED was constantly on. Trying to reset it didn't work as the red LED was always on.

 

I then connected the Evo to the Fortin program and upon selecting the "Evo-All Options" tab, Setting protection was turned ON (which I never did nor ever use) and once I turned that off to see the current settings, some options I had never selected where turned ON. Specifically, A1 --> A11 where now OFF and D2 --> E2 where now ON, as well as G3, G4, & H2.

 

Also, with out making any changes to the Evo-All nor flashing it, once I disconnected it from the Fortin program and went back to the vehicle to attempt a reset, the reset worked fine and the red LED wasn't constantly ON.

 

Any help appreciated. 

Connectez-vous pour répondre Voir 1 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer