Installed an autostart remote start and INT-SL+ into a 2003 Pontiac Montana and everything seemed to go well until it was all back together and tried to do a key takeover the security (lock symbol) icon is displayed in the information centre on the instrument panel. Tried the Q and A and followed instructions to cut Orange PK3 wire and atach one side to yellow and the other to yellow/black of the INT-SL+, tried this and did not change. Tried updating the firmware to V3.06, thought I had it fixed until vehicle was put back together and security icon still comes back on. Everything is normal starting the van with the key, everything is normal when remote starting. It's during takeover when the key is put into run and brake is applied to shut off remote starter that the security light comes on solid and stays on until vehicle is shut off and restarted with they key. Any suggestions, other than black tape over the light?
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
