After installing a Prestige APS787E alarm w/ my Evo-All bypass module on my 2012 Nissan Rogue (Non-Push2Start), my lock, unlock & trunk buttone on the aftermarket keyfob work but the remote start doesn't work. I updated my Evo-All to the latest firmware & hardware available & flashed it to D2D protocol.
I also programmed the Prestige alarm using the install guide to get the Tach signal via D2D mode. But when I attempt to follow the "Tach rate progarmming" section of the manual, it is clear the alarm might not be getting a tach signal.
Is it possible to hardwire the tach signal to my alarm while using data mode w/ the Evo-All?
Secondly, I test the "ground while running" wire connection btw the Evo-all & Prestige alarm with a multimeter and I get a constant 12V even when trying to remote start. Is this normal? I thought it would/should give me a 0V or ground signal when I attempy to remote start the car.
Lastly, also just noticed that my Prestige key fob arms the aftermarket alarm but locking my doors w/ the OEM Nissan keyfob doesn't. Thus when I arm the car w/ the Prestige keyfob & unlock & open the doors w/ my Nissan key, the siren goes off. Is this normal?
Thanks in advance
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
