Previous same question never posted to site?
Evo-Ride hardware v3 firmware 2.03, hardwired into 2003 Altima with 8 pin immobilizer connector, will not program. Remote starter works fine with key in ignition. All programming steps and LED blinks are good until key is turned on. Red LED goes solid red every time. All immobilizer wiring checked, metered, and confirmed correct in factory service manual. While troubleshooting, I found that pressing the programming button 5x (instead of 4x) then turning the key on, the red LED will blink 10x like it was programmed correctly. But the car will not remote start and the red LED stays on solid even after remote starter shuts down. Repeated programming process, same results. Tried another new Evo-Ride, exact same problem.
Can the Evo-Ride be reset or firmware upgraded if needed?
Any help will be appreciated. Thanks!
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
