English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

25/09/2022

 Nissan Samione90 (130Pts.)

0

Hello! Which EVO kit and T-HARNESS will fit my car? Nissan Teana L33 2014 Europe.

Эта машина на платформе Altima! Но только европейской сборки. Мне интересно, куплю ли я комплект EVO All NIST4. Подойдет ли распиновка проводки и жгута для моего автомобиля?
Connectez-vous pour répondre Voir 1 réponse(s)

02/05/2021

 Nissan Eric Laing (390Pts.)

0

2016 Juke parking light wire resets car features

I have 2 2016 Nissan Jukes, yes, his and hers. My starter works fine and turns on the parking lights (brown wire to purple wire of green pin1 at BCM connector), when I put the brown to purple in my wifes car, the lights don't turn on and it resets the radio/time to factory, every time. Again, identical 2016 Jukes. I am NOT pulling the starter out of her car as where I have it tucked in takes a long time to get at. Verified 12v at purple wire with manually turning on the parking lights but when remote started the Fortin brown wire has nothing. Ideas?
Connectez-vous pour répondre Voir 3 réponse(s)

02/05/2021

 Nissan Eric Laing (390Pts.)

0

2016 Juke parking light wire resets car features

I have 2 2016 Nissan Jukes, yes, his and hers. My starter works fine and turns on the parking lights (brown wire to purple wire of green pin1 at BCM connector), when I put the brown to purple in my wifes car, the lights don't turn on and it resets the radio/time to factory, every time. Again, identical 2016 Jukes. I am NOT pulling the starter out of her car as where I have it tucked in takes a long time to get at. Verified 12v at purple wire with manually turning on the parking lights but when remote started the Fortin brown wire has nothing. Ideas?
Connectez-vous pour répondre Voir 3 réponse(s)

02/05/2021

 Nissan Eric Laing (390Pts.)

0

2016 Juke parking light wire resets car features

I have 2 2016 Nissan Jukes, yes, his and hers. My starter works fine and turns on the parking lights (brown wire to purple wire of green pin1 at BCM connector), when I put the brown to purple in my wifes car, the lights don't turn on and it resets the radio/time to factory, every time. Again, identical 2016 Jukes. I am NOT pulling the starter out of her car as where I have it tucked in takes a long time to get at. Verified 12v at purple wire with manually turning on the parking lights but when remote started the Fortin brown wire has nothing. Ideas?
Connectez-vous pour répondre Voir 3 réponse(s)

02/12/2020

 Nissan Wesley Bridges (140Pts.)

1

2015 Nissan Altima Ignition Ignition 2 wire

Not a question so much as an update to your notes. On the installation instructions it shows Ignition 2 as Pin 9 Black 24 Pin plug as a Pink wire. Vehicle I had it is not a Pink Wire it is Brown but when tested goes + when PTS is hit for ACC or IGN.
Connectez-vous pour répondre Voir 1 réponse(s)

28/01/2018

 Nissan Nodier Vallejo (1030Pts.)

0

dark blue wire, driver door trigger - does not work

I have a 2011 nissan rogue intelligent key, I installed an evo one, everything works perfect, except the trigger of the driver's door (auto lights shut down ) dark blue cable, connect this cable to the negative of the door trigger, exactly as the instructions say , but I have the problem that when starting the remote start the vehicle turns on but after 2 seconds it turns off, check the problem and I find that when the remote starter start the dark blue wire  gives a constant negative discharge and the sensor of the door trigger shows as if the door were open, I do not really understand what this dark blue wire is for and what function it has, disable it and the car lights normal, my question is what should I do or what is the problem, or I must configure thanks.

Connectez-vous pour répondre Voir 1 réponse(s)

30/04/2018

 Nissan Jehad Alyousef (190Pts.)

0

where does the A8 (dark Blue) wire connects on 2015 Nissan Armada Intelligent Key?

I just want to make sure that the meant by "The Driver Door Pin" where the A8 Dk. Blue wire connects is that switch located at the body frame and controls the inside capin lights? is this is the correct interpretation? Thanks
Connectez-vous pour répondre Voir 1 réponse(s)

14/01/2018

 Nissan James Schmidt (130Pts.)

0

Are Lock unlock A2 and A3 optional 2010 altima PTS EVO All

If A4 and A5 are hooked up, do A2 and A3 need to be hooked up, and vice versa?
Connectez-vous pour répondre Voir 1 réponse(s)

03/01/2017

 Nissan Vincent McShane (130Pts.)

0

I cannot get Flash Manager to save options with EVO ALL

Have EVO-ALL NIST 1, service #001A06680216 and Flash-Link-4, service #002504 043308 for a 2013 Nissan Maxima PTS. Flash updated module to hardware version 6, firmware version 72.24. When I try to save options for 3X lock in flash manager the device immediately disconnects and message appears: "The current unit does not support this feature". How can I get module to accept changes?
Connectez-vous pour répondre Voir 1 réponse(s)

12/01/2016

 Nissan jordan maxey (190Pts.)

1

Evo-one on 2010 sentra does not remote start

I followed wirecolor.com instructions and got the evo-one to program CAN and all that so i know im on the right track, but when i push lock three times on factory remote it does not start
Connectez-vous pour répondre Voir 2 réponse(s)

12/01/2016

 Nissan jordan maxey (190Pts.)

1

Evo-one on 2010 sentra does not remote start

I followed wirecolor.com instructions and got the evo-one to program CAN and all that so i know im on the right track, but when i push lock three times on factory remote it does not start
Connectez-vous pour répondre Voir 2 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer