Hello, installed a Prostart CT 3471 TW with Evo-all into a 2009 Mitsubishi Lancer, manual trans, key start. The fortin evo-all guide for lancer asks for firmware version 2.02 or higher. The bypass module would not program with this version, but would program with reccomended newest version. My problem is that the the tach, foot brake, e-brake are all supposed to input to Evo-all through CAN HI and CAN LO and output to remote starter through D2D. I can get foot brake function to work with key on but no tach signal or e brake signal. The WIRE COLOR vehicle wiring color guide says to use coil on number 1 BLK/RED wire for tach signal. I connected to this wire and cannot tach learn remote start. I ended up using an injector neg. wire (any wire not red/white) and immediately was able to tach learn. Had to also hard wire e brake wire to get signal to remote starter. When using this combination of starter/bypass, what protocol should I select in evo-all and remote starter, my options are fortin, xpresskit, D2D, one way or 2 way communication? Should I have to hard wire Evo-all to remote starter inputs or should it all be going through the D2D. Thanks, Mike.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
