So I have evo-all with the t-harness for my 2014 mazda 3 push to start auto, and I updated the firmware and then went through the programming procedure and successfully completed it, but my car did not start with the 3x lock. I then realized my safety switch was in the wrong position (shorted to ground) so I switched it back and tried and still nothing. I then thought maybe this made the whole procedure invalid since that switch was in the wrong position, so I attempted to reprogram from the start. I basically got a bunch of leds on/flashing that aren't even mentioned so I figured this wasn't going to work and then I eventually found out that I had C1 and D1 disabled in the evo-all options. I enabled them and the flash link software says its still ready to use. I'm wondering how to reconnect it, as in what led to wait for when holding the programming button, or have I messed up my evo-all by trying to reprogram and what should I do now?
Thanks,
Trevor
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
