English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

24/10/2024

 Lincoln Shawn sri (460Pts.)

0

2017 lincoln navi door locks not working on evo start 2

I just installed a evo all and evo start 2 on 17 navigator, I followed the 2015 guide since there was no 2016 and 2017 available everything works but the only issue right now is on the evo start 2 app I can remote start but the lock and unlock does not work is there anything i can do to fix that . thanks
Connectez-vous pour répondre Voir 1 réponse(s)

08/01/2024

 Lincoln TK81 (130Pts.)

0

2007-2010 Lincoln MKX EVO-ALL FORT4/FOR4 No Start

I'm encountering a no start condition with EVO-ALL (SN: 001A07511504) and THAR-FOR4 T-Harness in a 2009 Lincoln MKX. It programs correctly (i.e. ending with 10 red flashes then rapid blue flashes). When remote starting it goes through the motions but the engine never cranks. I currently do not have A4 (green wire - unlock) or A5 (white wire - lock) installed from the 20-pin connector as from my understanding it's only required for a RF kit. I will be installing a MyCar module but want to ensure I have the basics working first before connecting the other wires to the BCM. NOTE: The unlock wire color seems to be incorrect for the 3B BCM connector in Guide # 89131 rev 20220805. The manual states Purple/Green but the actual color is Purple/Grey. Wirecolor also lists the unlock wire as Purple/Grey.
Connectez-vous pour répondre Voir 1 réponse(s)

19/02/2017

 Lincoln Josh Ley (500Pts.)

0

EVO ALL in 2010 Lincoln MKX won't program

I reviewed the other post on this exact issue. At first attempt programming (using programming 3--2 keys) the red led flashed and then blue led flashed. The vehicle wouldn't remote start. I attempted a dozen times changing firmware (4.18, 71.39, 71.35, 71.34, 71.11) and programming using the two key method as well as decryptor process and single key. When attempting to program using the two key method, the red led does not flash, nor does the blue led flash. When using decryptor method, after uploading/downloading and updating the module, the vehicle will not remote start, the security light flashes on the dash indicating no valid key. If I hold the key next to the barrel it will remote start. i swapped out the evo-all for another, same result. I swapped out the evo-all for an evo-ride, the red led does not flash when I press the program buttton. RX (lt blue/blk) is connected to the yellow/org pin 4 of transponder TX (lt blue) is connected to purple/grey pin 3 of transponder connector. I tried swapping RX and TX, module wouldn't go into correct programming mode. I tried using the guide for Ford Edge, connecting evo-all relay output (Wht/blue, wht/red) to +12v, ign. 5 hours troubleshooting this thing. Normally changing firmware solves these type of issues, but I am at a loss.
Connectez-vous pour répondre Voir 1 réponse(s)

21/12/2016

 Lincoln Jose Rodriguez (130Pts.)

0

2004 Lincoln Aviator

I am new to the Fortin line and i have been using the EVO-ALL and EVO-ONE mostly on newer cars and trucks. My question is will a EVO-ONE/REVO 1 rf kit combo do remote start on a 2004 Lincoln Aviator since it does not have CAN wires?
Connectez-vous pour répondre Voir 1 réponse(s)

10/05/2016

 Lincoln Douglas Dingman (150Pts.)

2

Does a 2006 Lincoln Mark Lt require a key wrap?

I am installing a fortin evo one in a 2006 Lincoln Mark Lt and am having the same problem as described in this question: https://wirecolor.com/en/qa/65986/evo-one-remote-start-works-dcryptor-bypass-does-not Was this question ever resolved?? I have called tech support and the last very friendly guy i spoke with thought I might have to do a key wrap. I would like to avoid that if there is a better solution. I have done most of the same steps that he has to include swapping the tx and rx wires and even rolled back to .62 and no help. I get the same issue at step 6 of the module program where the yellow light goes out but the red comes back on. I don't have the service number right at hand for the unit but can get it later if its needed to answer my question.
Connectez-vous pour répondre Voir 1 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer