Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

Mycar not working properly with evo

Mycar Lt2 won't work properly on evo one I believe it's paired as I can send commands,shows gps,battery. So problem is if I ready car then later send start signal it will start run a few seconds then shut down and unready vehicle also when I send lock/unlock it sends it three times on either senario as well as it always shows green unlock doors in the middle no matter what state car is in volt and gps seem to work okay I'm trying to get this module up and running please

04/12/2022

Honda JamesC (130Pts.)

0

Evo One, how to decrease crank time

First time Fortin user here.  Purchased a pre-programmed  EvoOne and an Omega OL-RF-32-SST from a trusted Fortin distributor. Vehicle info: 2005 Honda CRV, (gas engine, auto trans, keyless entry, no factory alarm).

Clean install which went very smoothly.  Everything functions as it should.  However, when I call for a remote start command, the vehicle will start and run but over crank by a sec or so causing a starter grind.  WITHOUT a Flashlink V4/Manager Software...followed programming procedure OPTION 3 Tachless Sensitivy to decrease crank time using the antenna button and rf remote button method, but can not get a park light confirmation of the changes I made.

My assumption.  IF my distributor enabled Master ON on the module during initial programming, changes made using the said method above does not function correct? and the only way to make that change is through Flashlink/Manager Software?

0

How do you connect a nonbranded transmitter to the evo-one? What antenna is used?

I see that the evo-one is compatible with non branded transmitters, but how does it connect to the evo-one module if it doesnt come with an antenna. The unbranded remotes, when purchased, do not come with antenna or cable to attach to module. So if I wanted to connect an Omega transmitter to my evo-one, will I have to buy a fortin antenna and cable separately or use an omega one?

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer