Issue 1: The remote starting fails to successfully start the vehicle.
During cranking the dash security indicator continously flashes, this indicator is normally only flashing when the vehicle has been locked. The dash security indicator begins to flash after the vehicle is shut down by the remote starter (from Ready Mode) and continues to flash until the vehicle is unlocked with the remote.
Parking light flashes four times after each failed cranking attempt.
Ready mode is operating as indicated, pressing brake while engaging the parking brake, then lifting off. One parking light flash is indicated, the Red and Ylw leds on the EVO are on, and the motor continues to run until the driver door is open then closed. Once the vehicle is shut down the dash security indicator begins flashing.
Blue Led flashes with each Lock Key signal from the OEM fob. After three lock signals the Red and Ylw LEDs on the evo turn on and the start sequence begins. The dash indicators come on and the dash security indicator led remains flashing. The starter is being actuated and the engine is cranking but the car does not successfully start.
Issue 2: Opening Red Wire on 4P clutch conenctor causing VSA and parking brake errors
In addition to the HON7 t-harness, Cut3, tap on Ylw line of Clutch Position sensor, and open of Red line on Clutch Stroke sensor (type R only) has been performed.
Without the opening of the Red line on the Clutch Stroke sensor the car will not activate the starter motor during remote starting unless I manually press the clutch pedal. Once the Red line is opened as instructed, the remote start does actuate the starter motor, but now during normal operation there are now CONSTANT VSA and PARKING BRAKE ERRORS indicators on the dash. The vehicle does run and drive but with errors.
I posted this link in my earlier question, but it appears that opening the Red line causes the VSA system to malfunction and putting a relay on the Ylw line of the Clutch Stroke sensor maybe an alternate method? I am not sure how to do this with the EVO configuration.
https://github.com/JW0914/Wikis/blob/master/Automotive/FK8%20CTR/Compustar/Alarm%20%26%20Remote%20Start%20Install.pdf
Please advise on updates or alternate configuration. My setup specifics are listed below:
Vehicle: 2019 Civic Type R PTS Manual
Bypass HW: 4 FW :3.32
Remote Starter HW:7 FW 1.24
T-harness: HON7
All reccomended options were loaded for both Bypass and Remote Start, only the Ready Mode Option was modified from 33.1 to 33.2.
The decryptor programming was performed twice with nominal LED and Flah Link Updater feedback
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
