Devive: EVO CHRT6 included
EVO ALL Service # 001A06220014
HW: 6
FW: 4.18 Updated to 7.32 via Flashlink updater2 Manager version 3.62
Tried to install into 2017 Dodge Journey push start button.
Followed guide# 12211 Rev 20160914 stand alone
connector A:
A1 Yellow to Pink/white (Starter wire)
A10 Blue to Lt Blue /Black T-Harness
A18 Green/Red to Parking light White/Brown
A20 Light Blue to Lt Blue T-Harness
A8 Hood Pin . . Not connect yet
A15 Pink/Black . . Not connect yet. Too hard to reach ( Is this caused Problem ? )
Connector C:
C4 Gray/Black to CAN LOW
C5 Gray to CAN HIGHT
Follow Programming on page 5/9 of the installation guide . .
On step 6 with the key fob without battery placed close to start/Stop button. Press start/Stop button twice as required but the button light Not change to ACC or ON the Ignition at all. Also the yellow light on the remote Starter not change at all.
I tried to reprogramming from step 1 down again and sitll got the same issue on step 6
Repeat again with key fob battery placed on at step 6, the light Start/Stop button changed from OFF to ON ignition, But the yellow light from remote starter not change . . .
Would you please look thru and Help me to solve this programming issue.
Thank you,
Minh Le
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
