After many failed attemp with tech support today to install my EVO. Now my security light is permanently on after I removed all the EVO harness and Evo All. The car starts and runs so far. Please I hope there is something I can do since going to the dealer for demobilizer problem is easily a $590 dollar bill. I believe the evo must have changed my security settings.
Below was the original install issue. I have decided to take the vehicle to a shop for a fresh install with a fresh unit and system but I have to have the security light back to normal or they wont touch the car.
----------------------------------------------------------------------------------------------------------
Car 2011 QX56
EVO-ALL & THAR-NIS1 Stand Alone Service # 001 A06 585175
Guide #12681
During programing when I get to #7 The red sometimes turns off and only blue is on. I have only been able to get both red and blue to stay on twice very briefly.
In the instances when they stayed on, following the next step #8, Pressing the start and stop button x2 does not turn on the ignition. If you press it a third time or jump to #9 the the inginition turns on and it flashes rapidly. If I go continue with the programing, the result is that the car does not remote start on pressing 3 times. Basically nothing happens, it simply locks the door 3 times.
I have an updated firmware. Did the update all over again yesterday successfully. I have been on this thing for the past 2 days. Have not done anything else all weekend.
I am at my wits end with this thing. Somebody help.
Service Number : 001 A06 585175
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
