Recherche rapide
Trouvez la bonne solution pour votre véhicule.

Questions & Answers

Wire/wires for Valet Switch

+1 vote
EVO-CHART4 Stand Alone / T-Harness.. 2015 Town & Country...

For the Hood/Valet Switch - is this a single wire hook up?

For the switch should the hood pin wire(A8) go to one terminal on the switch and the other terminal be grounded? OR should the 2nd terminal use the external input wire(A13)?

I assume grounded...
posté Dec 16, 2015 dans la catégorie Chrysler par John S (240 points)

1 Réponse

0 votes
A8 is a hood pin to set the evo all in valet mode when hood open, prevents the module from accidentally remote started. So when the dark blue wire (a8) is at ground the vehicle will not start. It is a single wire drk blue wich gets connect to a hood pin. A13 is a external start stop trigger. So if this wire is pulsed negative the vehicle will either start or stop.
répondu Dec 16, 2015 par derek ! (278,800 points)

So then for the valet switch it would use the same hood pin wire (A8) and/or a jumper wire from A8 to a terminal on the switch, the other switch terminal would be grounded?

 

Using the same wire A8 for both a Hood Pin OR a Valet Switch... A jumper off A8 if both are used together.

 

So when the switch is closed, the A8 is grounded - preventing starting..
As I asume the hood pin body would be grounding itself in a bracket, depressed circuit is open/ungrounded allowing for remote start...

 

Thanks

Anytime ground is present on A8, the evo would not allow remote starting.

You can use both hood pin and a valet switch for an ultimate secure shut down.
...

Wirecolor.com

Le savoir-faire au travail

WireColor.com est l'ultime outil en ligne pour les installateurs de démarreurs à distance et de systèmes d'alarmes. Le site fourni des informations sur le cablage et des photographies détaillées des processus d'installation.

Infolettre

Recevez nos nouveautés
par courriel.