Recherche rapide
Trouvez la bonne solution pour votre véhicule.

Questions & Answers

2003 Miata not programming

0 votes
First, how do I know what hardware and firmware version my module has? Its not on it or on the sticker. The first step in programming in the wiring schematic for this car is to plug in the 6 pin white connector, there is no 6 pin white connector. Which one did you mean to say? Im assuming the 4 pin black connector that has the power and ground wire on it. If so, then when thats plugged in (while holding the programming button) all the lights flash at the same time and the red one never remains on allowing me to go to the next step. What do you suggest? Thanks
posté Juil 25 dans la catégorie Mazda par Aaron Gibson (130 points)

1 Réponse

0 votes
sounds like you have an EVO-ALL, which is immobilizer bypass vs the EVO-ONE which is remote start + immobilizer bypass.

 

Either case, all three lights flashing indicate that the module has never been flashed. This is done from the flash link updater programming tool.
répondu Juil 25 par Robert T (280,410 points)
Okay thanks, just ordered the updater. But yes, it is the EVO-ALL, that's the installation guide I have been going off of (https://fortin.ca/download/80941/evo-all_ig_reg_bi_maz_mx-5_2002-2005_key_a_80941.pdf). Is there a different or updated guide I should be referencing? Thanks
It's the proper guide. It shows wiring and programming of the EVO-ALL, plus the suggested wiring of whichever 3rd party remote starter you are using.
...

Wirecolor.com

Le savoir-faire au travail

WireColor.com est l'ultime outil en ligne pour les installateurs de démarreurs à distance et de systèmes d'alarmes. Le site fourni des informations sur le cablage et des photographies détaillées des processus d'installation.

Infolettre

Recevez nos nouveautés
par courriel.