I'm trying to add MyCar to a Fortin EVO-ONE installation on a Subaru Outback 2017.
The Fortin EVO-ONE works fine - I can start the car using the OEM Standard KEY/Remote without any issues.
I followed the steps provided in the install guide to add the MyCar
Protocol is set up to Fortin2 using the FlashLink MAnager on EVO-One for RFKit
Setup as Fortin in the MyCar application Settings.
I did the following steps to learn the MyCar into Fortin EVO-One
1- Cycle the ignition to the ON position.
2 - The YELLOW LED on top of the EVO-ONE should come ON.
3 - Press and Hold the EVO-ONE push button for 5 seconds.
4 - The parking lights and the RED LED on the side of the EVO-ONE will turn ON.
5 - Release the push button.
6 - Press and Release the push button 5x times. Everytime the push button is pressed the parking lights and the RED Led on the side of the EVO-ONE will blink.
7 - Then Press and Release the Brake pedal.
8 - Seconds later the RED LED on the side of the EVO-ONE will blink once to confirm that the MyCar ID has been learned to the EVO-ONE.
9 - Cycle the vehicle’s ignition to the OFF position to Exit the EVO-ONE programming
All steps succesful.
In the MyCar app I can see the voltage of the car and the GPS location, however the START/STOP/LOCK/UNLOCK functions are not working from the MyCar application