Ok triple checked all connections, mounted ODB connector back in place and reconnected battery. Have only hooked up the module with the harness connection and the 20 pin connector, have not hooked up the data link and the odb connections. Both the 1st remote and 2nd remote are working, can start car, can lock/unlock as though nothing happened. There are some permanent codes on the ODB status that my reader cannot remove as it says that they are permanent, I think not a big deal because this is most likely from the bad wiring I initially did. So at this point since I did a master reset and no longer have the dcryptor I will continue at that point. Again only thing I need to do is hook up the odb connector and the data link one that requires me to hold until I get to blue led. Will report back with results.