2019 Ford Explorer Base model key start with EVO ALL standalone. With fort3 harness as well. Running 4.01 firmware, and seemed to be successful programming after I went in with forscan to activate remote start on the BCM and IPC. It goes through the motions after I hit lock/unlock/lock. Red LED comes on, then yellow, then blue flickers with a single horn honk/parking lights flash. It does this again, and then I get 3 red LED blinks, which I know means no tach/no start. Is there any other settings that need to be turned on in forscan? I have a toggle switch instead of door pin. I also tried disabling hood switch in forscan, and the same thing happens.