Recherche rapide
Trouvez la bonne solution pour votre véhicule.

Questions & Answers

Blinking amber light on start button 2016 CX-5

0 votes

The module seems to work fine, I have completed every step in the installation guide. However, the start button does continuously blink amber/orange while the vehicle is running and does not stop until the engine is shut down. This only happens when started normally, not remotely. If I disconnect power to the EVO ONE, the car can be started just fine and there is no blinking light. I used the THAR MAZ 3 t-harness to install. I have been scouring the Mazda forums and have found no answer. Everyone says either replace the fob batteries (I replaced them) or visit the dealer. The mazda dealer wanted $150 to diagnose the problem, and then doesn't want to even look at it after learning the Fortin system was installed. 

posté Dec 12, 2020 dans la catégorie Mazda par Ryan Smith (130 points)

1 Réponse

0 votes
Tharness is not fully seated or theres a faulty terminal.
répondu Dec 15, 2020 par Robert T (284,630 points)
...