EVO-KEY service number 002A02 040238
Hardware Version 2
Firmware Version 1.07
Date 09/2016
Vehicle: 2008 Kia Sedona
EVO-KEY is wired as per Guide #15461, Rev 20140930. Connected to Pro-Start CT-3271 remote starter via datalink. I have confirmed that Data wires are not reversed. I have also confirmed that there is +12V @ ignition wire when key turned to "Run", 0V when key off, and this voltage is being seen at the A2 pin of the 6 pin connector.
Steps 1 to 3 in Programming Procedure followed and ok, however when key is inserted and turned to "Run" the yellow LED remains on and the red LED remains off. Have reset the EVO-KEY as per instructions here: http://fortin.ca/en/qa/49063/reset-evo-key?show=49063#q49063, with no change in the result.
What am I missing to get the EVO-KEY to program?
Thanks.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Buick
Cadillac
Chevrolet
Ford
GMC
Hyundai
Kia
Mazda
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
