I have a 2016 Mazda 3 Automatic that I've wired with the EVO-ALL module and MAZT1 T-harness. It is wired and programmed but it doesn't start.
Wiring: Using the diagram #62681, I spliced the 20 pin harness light blue wire A20 into the 32pin #9 for door lock data and the light blue/black wire into the 32pin #8 for the data key. The rest is connected with plug n play t-harness and I wired the parking lights as described as well. Also, I made sure the dark blue wire A8 for the hood pin is grounded properly.
Programming the module: I went through steps 1-12, received feedback appropriately and used the dcryptor. Then repeated those steps, got the flashing blue and red feedback, proceeded with the final steps of can-bus programming and again received the correct feedback with the blinking blue lights.
When I leave the car, I use the lock-unlock-lock (this is how I chose to program the settings) on my oem remote. I can visually see the module flash blue with each input of the remote through my car window, but then nothing happens. My only concern is that I tried to program it too many times as I initially thought I could use the single key install guide, then had difficulty with my second key with switching the programming method and thus had to have Fortin reset my module since the dcryptor had been used 3 times. Is there something else I can do to get this working such as a simple setting change? I truly think all the wires are in the right place and since I got the light feedback from the device while programming the keys, it seems like it should work.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
