I have a 2000 ford excursion with the 6.8 v10 and I have just installed a mpc remote start kit number 4232. After installing by soldering in a bunch of wires I got to the key programming stage where a fortin instruction page is included and I follow the steps it says but the red light on the key override all module won't blink the 10 times like it says it should. If I plug the antenna in it will put the truck into run mode and begin trying to crank the motor but will not fire leading me to security issue because the key won't program. The instructions say for the ignition switch connector I should have connector H but in reality I had connector C so I connected the tx and rx wires as instructed but I am confused to where to go next
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
