Installed a Compustar CS300 with a Fortin INT-S+, used the suggested #7 install instructions from the Fortin install sheet. The vehicle will start for a few seconds then shut off. I took the INT-SL+ out of the car, hooked it up to the flashlink module and flashed it to 3.06 firmware. Once back in the car, held down the program button and plugged in the module, LED illuminated. Then plugged in white connector and LED stays lit. Press lock on the remote start and it goes off. Turned the key to Ignition and the LED never blinks. Still wont keep the car running. I don't think it's "learning" the car? Tried locking the doors and starting, when it shuts off the red security light on the dash blinks two fast then one.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
