I installed the evo-fort1 in my 2013 ford f150 tonight I really only care about the remote start feature. It starts fine with the 3X lock and will turn off with it as well. one concern is that I can get inside the truck and drive it without the key when it was started with the remote start ( I would assume only for 15 minutes) I would like to figure out how to have it shut off when the brake is pressed or not let you put it in drive at least. My 2nd and main concern is that when I start it via remote start get inside, if I put the key in the ignition and turn it to the run position and try to turn it off after 5 minutes or so it will not turn off and I have to do the 3X lock to turn it off or wait till after the 15 minute runtime. I followed a youtube video from an installer that only connected the can high and can low which is what I did for now. When I programmed it using the flash link did I turn on or off a certain setting? I believe I had on remote start, with keybypass? what correct settings should I have on
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
