Installed a EVO-ONE into my 2015 Subaru XV Crosstrek w/ Push-to-Start. I have no issues with the remote starter, bypass, locks, etc. Everything works great with a Fortin 2-way RF kit - which I am still temporarily using until I figure out how to get my DSM300 Smartstart to work. I didn't find the Smartstart guide particularly useful in regards to wiring it up to the EVO-ONE for my application. I had programmed the remote start to XL202 and grounded the gray D2D mode cable as per the Fortin guide. Can someone clarify if I am to use the white D2D connector that is included with the Smartstart's multi-connector harness and does it plug into the larger antenna port? Or do I need to make up a cable to go to the black Fortin Data-Link/Flashlink Port? Do I assume that I will have to power the Smartstart separately using its own 2-wire harness w/ 3-Amp fuse since the EVO-ONE isn't providing 12-Volts from the data ports? If so, do I remove the 12V power on my connection back to the EVO-ONE? I tried powering them separately and just leaving the data wires + ground, but I could not pair the Smartstart to the EVO-ONE; I sent a lock command which the Smartstart app said was successful during the pairing process as per the instructions I found, but I couldn't get the EVO-ONE to acknowledge the signal to pair the Smartstart. I hope someone can steer me in the right direction. Thanks
- Chad
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
