2009 Uplander sometimes will not remote start. Evo-all is hardwired to ProStart. (Lt.blue/black from Evo-all is not connected to the vehicle. The tan/white wire in the vehicle is missing). However the evo-all module programmed fine. Half the time, the vehicle remote starts on the first try, the other half of the time, it will either remote start on the third try or it doesn't remote start at all. The vehicle remote starts all the time if the key is placed in front of the ignition. Does the lt.blue/black have to be connected? If so, where do I connect it if the tan/white wire is missing? Also, if it does remote start, "starting disabled" flashes in the info center. This message does not show up if the van is remote started with the key in front of the ignition cylinder.
Comment: I just noticed that the installation manual says to use version 4.06 only. However, the recommended update given in Flash link was different..i can't remember exactly the version but it was in the 7x.xx range. Can this make a difference? I don't have the vehicle at the moment so I can't re-flash the module to see if it will make difference.
Any comments/inputs are greatly appreciated.
Thanks.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
