Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

25/10/2022

 Ford Chris Sexton2 (280Pts.)

0

EVO-ALL solid blue and red lights - will not program 2011 F-150 OEM keys

UPDATE: Added step-by-step procedures.

Issue: The blue and red lights on EVO-ALL remain solid during and after attempting programming with 2 keys.

System: EVO-FORT4; Firmware: 71.52; EVO-ALL S/N: 001A07355490; Vehicle: 2011 F-150 3.5L; Remote: Two standard OEM keys; Guide #: 94891.

Troubleshooting: Double-checked all connections. Double-checked settings. Re-flashed EVO-ALL.

Followed procedure:

    Program EVO-ALL and flash settings (firmware 71.52) Plug in all connections (ignition, immobilized, OBD) Manually connect "Key Sense" wire (A1, yellow, 20-pin connector) to the "Key Sense" wire (purple/yellow, either the 5-pin or 6-pin connector) Page 7; Step 1: Hold button down on EVO-ALL; connect black 4-pin data-link harness Page 7; Step 2: Release button when blue & red lights illuminate solid Page 7; Step 3: Connect other harnesses (white 20-pin, red 6-pin, white 5-pin) Page 7; Step 4: Insert key #1 to ON/RUN position Page 7; Step 5: Wait 3 seconds: remove key #1 Page 7; Step 6: Quickly insert key #2 to ON/RUN position Page 7; Step 7: Wait 3 seconds: remove key #2 Page 8; Step 8: Quickly insert key #1 to ON/RUN position; wait (blue light does not rapidly flash) Page 8; Step 9: Remove key #1
    Result: Vehicle locks cycle on and off (indicating key programming); however, EVO-ALL blue & red lights remain illuminated solid (no blinking). The truck responds correctly, but the EVO-ALL does not.


Note: There's a YouTube video showing that an initial data transfer programming step is needed prior to the step 1 in the guide (shown above): hold down the button on the EVO-ALL; release on blue; insert key #1; wait until EVO-ALL blue light rapidly flashes; remove key #1 to complete. This step is not in the provided guide. I attempted including this step after the 1st failed attempt, but the blue light never flashed rapidly. I received the same result below with and without this step.

 

The only manual connection I made is wiring the "Key Sense" wire (A1, yellow) on the 20-pin connector to the "Key Sense" wire (purple/yellow) on the other side of the EVO-ALL (either the 5-pin or 6-pin connector; can't tell with the harness).

 

Questions:

    Is there another connection I missed? Should the A1 yellow wire be connected to the other yellow wire (instead of the purple/yellow Key Sense wire)? Other than connecting the 4-pin harness first, do I need to connect the other harnesses in a different sequence?

Any help would be appreciated!

Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue