Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

06/01/2021

 Jeep Jason Moher (130Pts.)

0

2020 Jeep Renegade Push to start. Anyone tried it ? Won't program

2020 Jeep Renegade Push to start. Anyone tried it ? The cables and connecters are exactly the same as a 2018 guide Programming wouldn't pick it up on an EVO ALL + CHR6
Login to reply View 1 answer(s)

09/11/2019

 Jeep Jack Yoosabai (130Pts.)

0

EVO-ALL in 2004 Jeep Liberty will not program

2004 Jeep Liberty, no factory alarm, with transponder key. EVO-ALL is installed with a Compustar CS800-S. Used installation guide #3317, Connection #1, Program #1. Firmware flashed is 74.[38]. I can get the bypass to enter program mode (solid blue LED). When turning the ignition key to ON, the blue LED turns off and nothing else happens. The guide says the LEDs are supposed to turn on and off BLUE - RED - YELLOW in sequence, taking up to one minute. I waited 5 minutes with no lights turning on. Any advice?
Login to reply View 1 answer(s)

25/11/2013

 Jeep Buddy Williams (270Pts.)

2

INT-SL on 2002 Jeep Liberty, starts and dies

Cannot program bypass to start and keep running without key. Will start with key in or near key cylinder and will stay running when you move key completely away. No code after failed start attempts on Remote starter (basis 2 button Prostart). Data Interface is INT-SL, hardware Vr: 1, Firmware Vr: 3.01, Date 40-09. Installation guide that came with bypass is version 20120308. Download and used version Rev. J-28/01/2009 for programing Wired for installation without data-link. At step 6 of programing sequence, when key is turned to the ignition postion, LED goes out, but will not flash at step 7, no matter how long you wait. Can you reset bypass or test for faulty? Suggests? thanks Buddy
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue