Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

3

What is the correct way to connect wires?

T-Taps, Butt connectors 2 pounds of solder I've seen and heard it all...most of the time resulting in a headache and lost time. So i thought i would break it down and show the 5 easy steps to make a good quality and secure connection in a vehicle.

The 5 Steps are as follows:

1- Strip back the inulation of the wire you wish to connect to.

2- Seperate the braid to create an opening in the wire.

3- Insert the wire that is to be connected into the opening.

4- Close the wire.

5- Finally twist the wire around securing them togehter and finish it off with some electrical tape.

1

No LED's on unit after initial install

I completed all the intall wiring on my evo one on a 2007 mitsubishi eclipse, updated the bypass and remote start and when I plugged the unit in, I didn't see and LED's light up at all. Tryed to program the bypass, no LED's. removed the unit and tried to check the programming on the unit and it all seems to be fine. Looked in the Questions on the support site, and found that perhaps a master reset needs to be done. I can't seem to get any response from the unit on the car to do anything so I can't get into the programming mode to reset and can't get the red light during the master reset. What can I do?

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue