Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

23/10/2015

 Dodge Darren Asuncion (920Pts.)

0

2006 Ram diesel intake heater (glow plug) monitoring

Does the Evo-All have the ability to monitor the intake heater (glow plug) for remote starting? I see that I can set it for diesel mode, which would then delay the start signal for 0/10/20 seconds, but would rather just have it start as soon as the light in the dash turns off if possible. Thank you!
Login to reply View 1 answer(s)

24/09/2015

 Dodge dan zeigafuse (130Pts.)

0

2006 Dodge Diesel After remote starting and driving doors auto lock after turning ignition off.

If you remote start the truck it will relock when you shut it off. That includes after you drive it. For example, if I start the truck with the key fob it will unlock the doors, start the engine and relock the doors. Then I go outside and unlock the doors with the fob. I get in the truck, insert my key and drive to my buddies. Turn the key off, engine dies, I jump out but leave my key in the ignition or cup holder. About 10-15 seconds later the doors will lock again. Now I'm locked out of the truck. How to a stop this from happening?
Login to reply View 1 answer(s)

19/01/2015

 Dodge Dino Gerardi (130Pts.)

0

evo all wont program

try programing 3X on the oem remote blue light come on once i trun the key to on position light turn red and stay red then i tryed the rf kit blue and red led on turn key to on position to program . program the key once done turn key off red and blue start to flash test the rf key no responce this was on a dodge 2500 desiel 2003
Login to reply View 2 answer(s)

19/01/2015

 Dodge Dino Gerardi (130Pts.)

0

evo all wont program

try programing 3X on the oem remote blue light come on once i trun the key to on position light turn red and stay red then i tryed the rf kit blue and red led on turn key to on position to program . program the key once done turn key off red and blue start to flash test the rf key no responce this was on a dodge 2500 desiel 2003
Login to reply View 2 answer(s)

08/05/2014

 Dodge (Pts.)

0

3x Lock Remote Start - Compatable with 2007 Dodge 2500 Diesel?

I have a 2007 Dodge Ram 2500 diesel with automatic transmission and I'm wanting to confirm that the EVO-CHRT5 will work for me. I can't find any reference to the fact of using it on a diesel truck, the man page just says its compatable but with a 2007 Dodge Ram. Mike
Login to reply View 1 answer(s)

19/01/2014

 Dodge Desert Racer (160Pts.)

1

2006 Dodge Ram 2500, auto trans, 5.9 cummins diesel motor

I have a 2006 Dodge ram 2500, automatic trans, diesel motor. I have the following wired up I have the yellow and yellow wires from pin 20 connected to another yellow wire on t harness. Have the white/red wire to my starter wire on the truck Have the white/blue wire to my 12 volt sourc eon the truck. Have the yellow/red wire cut and using the end closest to the red connector connected to my ignition. I have the green/red wire connect to my mux wire on the truck. I have option 15 with diesel selected for 14 min run time. I follow the programming instructions in the book and the blue led flashes and works like it should. I press my lock button on the remote three times, the trucks fuel pump, radio turns on. Yet, the truck does not crank, I do not hear the starter making any movement. Everything is working like it should, just the truck does not crank and start/run. I have tried instructions from 9/20/13 to the latest ones on the website for wiring. I have also tried firmware- 4.09 4.18 74.07 I reprogrammed the module everytime I changed the firmware and/or wiring with no change. Everything comes on like it is suppose to. Just the truck does not try to crank over or run. Now if I stick the key in the ignition and crank it over, starts right up. When I press the lock button three times it won't start. I am at a lost at this point. I did not hook up the hood switch or parking lights, no need to and I do not want them. I follwed the wiring per page 11, letter F. I also followed the programing the remote/module exactly as descirbed and leds flash and do everything they are suppose to. I hit the lock button three times and truck turns the radio, fuel pump, and everything on. Makes no attempt to start the truck or no attempt to crank the truck over at all.
Login to reply View 1 answer(s)

07/01/2014

 Dodge Cody Legg (180Pts.)

1

How long are the EVO ALLS set to run when you turn the truck on with the key fob?

How long are the EVO ALLS set to run when you turn the truck on with the key fob?
Login to reply View 1 answer(s)

07/01/2014

 Dodge Cody Legg (180Pts.)

1

Dodge 2007 2500 diesel

I have a 2007 dodge 2500 diesel, what kind of device would I need that has a feature for warming the glow plugs up when it is cold and will have the key fob start feature where I can start the truck from out side of it?
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue