Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

09/02/2021

 Dodge Matt Johnson (130Pts.)

0

dodge charger 2014 step 5 blue/red lights not flashing using thar-chr6

Followed instructions in guide #97711 on a dodge charger 2014 automatic. Updated module using flashlink. Have A10 and A20 wires attached to same wires coming from harness, no other wiring. In step 5 where it specifies to push the button 1x to turn off the blue led and then it states that the blue led and the red led will flash. This never happens.
Login to reply View 1 answer(s)

09/02/2021

 Dodge Matt Johnson (130Pts.)

0

dodge charger 2014 step 5 blue/red lights not flashing using thar-chr6

Followed instructions in guide #97711 on a dodge charger 2014 automatic. Updated module using flashlink. Have A10 and A20 wires attached to same wires coming from harness, no other wiring. In step 5 where it specifies to push the button 1x to turn off the blue led and then it states that the blue led and the red led will flash. This never happens.
Login to reply View 1 answer(s)

18/10/2016

 Dodge Perry Rider (190Pts.)

1

Can't program key data into EVO-CHRT6 (Step 5)

Fortin EVO-ALL installed on a 2014 Dodge Dart. I did the install with a T-Harness, and purchased the Flashlink Updater 2 as well. I hooked everything up, and began to program the module. When I get to step 5 to program the key, I insert the key into the ignition and nothing happens. The red light does not illuminate, and the yellow light stays on. I've done a bit of research, and I have checked my lt blue wire and lt blue/black wire connections, and even checked for continuity through the t-harness connectors and I have continuity through the harness. I also tested the CAN-Bus by releasing on blue and turning on the key, and the blue light flashed and seemed to work correctly. After programming the CAN-Bus, pressing lock/unlock on my remote makes the blue light flash, and when I turn on my key, the yellow light comes on. I just can't get my key to program into the system. Any help appreciated.
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue