Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

FAQ - TSB (08-014-05) - 2004-2005 Chrysler Mopar Remote Start Inoperative

NUMBER: 08-014-05
GROUP: Electrical
DATE: February 17, 2005
SUBJECT: Mopar Accessory Remote Starter Inoperative Due To Hood Switch

This bulletin involves replacing the hood switch for the remote starting system.

 

Problem:

The vehicle operator may experience one or more of the following conditions:
- When the transmitter is pressed twice for start, the vehicle horn will "chirp" once but the vehicle engine will not remote start.
- When the transmitter is pressed twice for start, the vehicle horn will "chirp" twice, indicating a problem with the remote start system and the vehicle engine will not start.
- When the transmitter is pressed twice for start, the vehicle will "chirp" once, the engine will start and then turn off.
NOTE: The technician may not be able to verify the symptom(s) because it may be an intermittent condition.

 

Solution:

DIAGNOSIS:
If the vehicle operator describes one or more of the Symptom/Conditions, perform the Repair Procedure.

REPAIR PROCEDURE:
1. Open the hood.
2. Disconnect and isolate the negative battery cable.
3. Locate and disconnect the ground lead for the hood switch at the cowl.
4. Locate and disconnect the soldered joint on the other wire to the remote start hood switch.
5. Remove the remote start hood switch.
6. Install the new hood switch, p/n 05140473AA.
7. Solder the appropriate wire to the remote start hood switch back into the vehicle wiring harness. Refer to the service information available in TechCONNECT. Reference: Service Info, 8 - Electrical/Wiring Diagram Information/Wire - Standard Procedure - Wire Splicing.
8. Connect the ground lead for the hood switch at the cowl.
9. Connect the negative battery cable and reset the clock.
10. Close the hood.
11. With key and remote in hand, insure all the doors are closed and locked.
12. From outside the vehicle, press the transmitter button to remote start the engine. The vehicle should "chirp" once and then start. If the vehicle engine starts, no further action is necessary.

If the vehicle engine does not start, further diagnosis may be necessary. For diagnostic assistance with the remote starter system call 1.800.34MOPAR. Be prepared to furnish the last eight digits of the VIN, date of purchase for the remote start kit and the part number of the remote starter kit.

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue