Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Installation not complete on 2018 F150, last step left on solid blue

0 votes
Every step was complete as follows:

1) plug in T harness

2) while holding down black button connect the black plug on top of module

3) colors go through sequence, release on solid blue

4) plug in white plug of bottom of module

5) turn key to on position

....it does not go through rapid flash after this. Instead it stays solid blue.
 

ordered my flash link updates just in case. And helo would be great on how to get this working.

Ford 2018 F150 2.7 l

EVO-ALL

Service # 001A06879807

hardware Vr. 6

firmware Vr: 4.18
asked May 8 in Ford by Jordan Pyzer (160 points)

1 Answer

0 votes
you module is not flashed for the vehicle it is being installed in yet.

It needs to be flashed with firmware 4.01

It also needs to options enabled for remote start
answered May 8 by Robb (240,740 points)

Since you will be getting the flasher, might as well get your computer ready.

Create and account on fortin.ca and download the Flash Link Manager software here;, this will allow you to update the module: https://fortin.ca/en/flash-link-manager.html

 

This vehicle has two different solutions that use two different firmwares. Make sure to flash firmware 4.01 and not 71.XX. You will see a button called "view other firmware", select that then choose 4.01. 

Thank you for the response. What options exactly are needed to be enabled for this?
...