Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

No crank when using remote start or using the key to start car

0 votes
I updated the Evo one module to the current firmware and went ahead and re program process,during re programming process where I release programming button  when blue/red led them plug in the rest of connector then 6x press programming button then red/blue blinks 5x when I try to start car it does not crank at all.

also it does not let me do the dcryptor it says it has reach maximum limit.

now I can't even start the car with the key,no crank at all.please I really need help,thank you.
asked Jan 23, 2020 in Subaru by Edrice Iraola (1,060 points)

1 Answer

0 votes
What is the vehicle?


What is the service number to the module?


Did you wire in any interrupts into any circuits for the isntallation?
answered Jan 24, 2020 by derek ! (284,570 points)
It's 2017 Subaru Legacy(standard key)no I did not wire any interrupt that I know of.

service #002807-121019

"no I did not wire any interrupt that I know of."

- There are 3 interupts required in this installation. IMO, Data Door Lock, Security LED. 



This means when you try to start with the key, all connectors must be plugged into the unit.


Also, If you unplug the t-harness and return the stock connector does it start with the key?



It's 2017 Subaru Legacy(standard key)no I did not wire any interrupt that I know of.

service #002807-121019


sorry yes those interrupts you mention is connected

also I do not have T-harness anymore for almost a year already,it's hard wire.

and yes all connectors are plug in when I tried to start the car after red/blue led blinks 5x but it doesn't crank.
Start checking fuses, connectors and connections then...
1) I checked all fuses,connections,and I even re-did all wire connections and stil having issues after remote start 4flahses(no tach detected).

2) when programming module on step 2 after connecting all connectors and press programming button 6x. The problem is the second time I press the programming button the blue/red led would start to flash rapidly, it would not let me finish pressing the programming button 6x and would not let me start the car.

3)when I remove the module from vehicle I still can't start the car(No crank)with the key,but when disconnected all wires and connect all wires back to original the car starts fine,then I re-installed the Evo one but same problem like on 1&2 above,please I really need this resolved thank you in  advance.