Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Won't enter programming mode

0 votes

EVO-All unit being installed in a 2003 Jeep Liberty.  Using Guide #3317, page 7 gives the instructions for programming the unit.  I cannot get past step 1. Which states Press and Hold the Programming Button, insert the 4 pin Data Link cable (of which just only 12v and Chassis Ground are connected).  At this point the LEDs should start alternating flashing.

When the 4 Pin Data Link cable is inserted into the Fortin Unit all 3 LEDs continuously flash at the same time. Am I doing something wrong here or has this process to get into programming mode changed?

 

Thanks for any help.

asked Jan 11 in Jeep by Dave Lachance (130 points)
retagged Jan 11 by Dave Lachance

1 Answer

0 votes

Hi

This is exactly the same as my problem in my car 

EVO-All unit being installed in a 2015 Jeep grand cherokee V6 Using Guide #12201, page 5 gives the instructions for programming the unit. I cannot get past step 1. Which states Press and Hold the Programming Button, insert the 4 pin Data Link cable .  At this point the LEDs should start alternating flashing.

When the 4 Pin Data Link cable is inserted into the Fortin Unit all 3 LEDs continuously flash at the same time


Please anyone help us

answered Jan 12 by Hussain Jaffar (150 points)
edited Jan 12 by Hussain Jaffar

The lights flashing at the same time as you describe is because the unit has not been flashed or configured for your vehicle. You must flash firmware into the unit before trying to program it in the vehicle. 

 

I tried the method and the problem was solved

...