Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

2016 Wrangler Blue Light not Blinking during install

0 votes
I am at the point where i have the Blue LED and all the connectors attached.  Then when i turn the key to the ignition on/run position, the blue LED does not flash.

Not sure what the issue is, since i have used the flash link updater to update the fimrware.  Any suggestions?
asked Jan 6, 2020 in Jeep by Joe Miller (130 points)

1 Answer

0 votes
If the blue light is staying ON when turning the key ON, the problem is with the connection of the YELLOW wire, A1.

 

How the module is/was flashed can also cause it to not program. What is the 12 digit service number of the module?
answered Jan 6, 2020 by Robert T (280,410 points)
I was able to get the module working perfectly after i connected the yellow wire.

One more question, is there an guide on how to install the hood pin?
...

Wirecolor.com

the ultimate online tool

Visit wirecolor.com for wiring information and photographs providing detailed installation processes.

Email Sign Up

Get products & corporate
updates with our newsletter.