Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Tilt, shock and proximity on Evo-All

0 votes
Hello, i have to connect these sensors to my evo-all. can u tell me which wires i have to choose as inputs? I have to use diodes on the trigger wires sensors ? only one diode is enough ? or one diode for every sensor that share the same input? Thanks


I have dei sensors (504d 507 508) Thanks,
asked Aug 10, 2019 in Acura by paolo fast (820 points)

1 Answer

+1 vote
Best answer

This is the evo-all alarm guide, it shows you what each wire will do and which wires are used for sensor inputs. 


answered Aug 12, 2019 by Derek (182,540 points)
selected Aug 12, 2019 by Robb
Thx for answer, i will connect the dual stage proximity sensor and shock sensor to a3 wire, and tilt sensor to a2 wire, i have to use diodes on the a3 wire?
Yes, diode isolate is a good idea.