Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Has my immobilizer been damaged/reset?

0 votes
I have an EVO-ALL and EVO-NIST1 T-harness. I integrated the harness into my car with all necessary t-connections and soldered connections in place. When I attempted to follow the programming procedure, at step 7, I was only getting a solid blue LED. I re-attempted the procedure, same result. I started the car afterwards (with EVO-ALL disconnected), and my security light is now on solid red, indicating an immobilizer malfunction. I have tried leaving the battery disconnected (for at least 15 minutes), I left the car sit overnight (battery connected, another user here had a similar issue and it resolved itself overnight), and the light is still on when the car is started. If I pull the battery from either of my keys and attempt to start it by holding it near the start button, the car will give a "NO KEY" message.

What went wrong and how can I fix it? Currently I'm concerned that the device caused permanent damage to my car.
asked Feb 17, 2019 in Infiniti by DavidF O'Sullivan (210 points)

2 Answers

0 votes

If I pull the battery from either of my keys and attempt to start it by holding it near the start button, the car will give a "NO KEY" message.

 

Have only the red connector connected when doing that test. 

If the vehicle still does not start, put back the factory harness and try again. 

answered Feb 18, 2019 by Robert T (280,410 points)
0 votes
Very common on Nissan, after driving a couple miles it will  shut off.
answered Feb 19, 2019 by Mathieu Bertrand Collin (62,040 points)
...

Wirecolor.com

the ultimate online tool

Visit wirecolor.com for wiring information and photographs providing detailed installation processes.

Email Sign Up

Get products & corporate
updates with our newsletter.