Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers


0 votes

2014 Mazda 3 Automatic push to start. Using Guide #68451 for remote programming

I successfully installed the EVO-One with T-harness and the car starts with oem remote with no trouble. However, I am attempting to install the RF642W kit with no success.  When I plug the antenna into the Evo one it will briefly flash blue but then wont illuminate again under any circumstance. I can put the module in and out of valet mode with 3 presses however if I hold the valet button when the ignition is turned on, I don’t get a horn/chirp like the quick installation guide suggests and thus can’t complete step 2 of the programming process. The evo-one and rf kit are new and have not been paired with other devices. Any help as to where i am going wrong would be appreciated

Evo one sucsessfully installed using guide#68261


asked Jan 12 in Mazda by Michael Shave (130 points)

1 Answer

0 votes
I had to power cycle my Evo-one to get different antenna to program. Not sure if that will help you or not.
answered Jan 13 by Anthony Wilkinson (7,100 points)