Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

2018 Push To Start Ford Fort3 Evo-All

0 votes

I have the preprogrammed T-Harness clipped in properly with the black 4-pin cable and white cable in the Fortin programmer. I have waited till the light turns blue to plug the TWO connections in.

Once I turn on the push to start ignition, the light goes off. If I press the button it will begin flashing over and over again. After this if I turn the ignition off, the light stays blue.

If I click my remote  (I have updated the programmer and clicked LOCK UNLOCK LOCK), it flashes red, then both red and orange, clicks once and shuts off. It never hits all three colors to turn the ignition on.
asked Jan 7, 2019 in Ford by Kevin Melone (410 points)

1 Answer

0 votes
Best answer
You can not only plug the t-harness, you must do all other connections shown in the guide :

answered Jan 7, 2019 by Mathieu Bertrand Collin (61,360 points)
selected Jan 8, 2019 by Kevin Melone
Appreciate it! First time doing this, thanks for the help!