Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

2013 caravan not starting

0 votes
programming appears to have worked. blue led flashed with each press of oem fob lock. car does not start. purchased a packaged/pre programmed unit with t harnass. slick install. but no start currently. ground is good at black wire. power is good at yellow/blue wire. no signal apparent on yellow/red. no other LEDs flash or turn on.
asked Dec 9, 2018 in Dodge by adam luckhardt (130 points)

1 Answer

0 votes
Your module is not set for 3x lock. You need the Flashlink Updater to change the option.

Need to enable option D1.10
answered Dec 10, 2018 by Mathieu Bertrand Collin (51,100 points)
Bummer. E&B Electronics on Amazon was selling this with the understanding that it was fully programmed.... " Preloaded / Prewired ready to install module & T-Harness combo for your vehicle." "Latest firmware guaranteed" "Remote start your vehicle off your existing factory remote by hitting lock 3x!" https://www.amazon.com/dp/B00NBCF4VY/ref=cm_sw_r_other_apa_i_yeVdCbTEYPW6G. I'll get with them to see if it can be rectified without my having to purchase the link
Have you resolved this yet?  I have the exact same issue with the same van.
...