Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

EVO-MAZT1, Guide 62951, 2015 CX-5 step 16 then to 1-12 steps

0 votes
I get as far as step 15 , install the Dcryptor, then step 16 says to first install the 4 pin data connector, then the other connectors, step 17 says to go back and repeat steps 1-12. Does this mean remove all the connectors that step 16 asked me to install before starting at step one again, or just disconnect the data connector and press and hold the program button. I am a little confused on how to repeat steps 1-12 again if step 16 asked me to install all the connectors and never asked me to remove them.
asked Nov 19, 2018 in Mazda by Tim Dreher (210 points)

1 Answer

0 votes

There are 3 parts to that programming. 

  • Key Dcryptor
  • Vehicle learning of module
  • CAN programming

 

Part 1 and 2 are the exact the same steps aside from the leds flashing different after the 2nd pass. 

Your 1st part went thru OK. Now you need to do the 2nd part which is just a rinse and repeat of the process. We ask to reconnect the module after the first part so that module re-initialises in the car. Disconnect it after.

answered Nov 19, 2018 by Robb (191,720 points)
Thanks for the reply. So let me be 100 % on the process, after dcryptor, install the module as per step 16, do I need to turn on the car to initialize it or does just connecting it in the step 16 process initialize it ? Is there certain process to disconnect after step 16, as in data link first or last off. Also when I do step 1-12 will the leds give the same results as the first time through. When you say the leds flashing different after second pass, I assume you are comparing step 13 to 18. I have a bad head cold so my brain is fuzzier than normal. Really appreciate the help.
...

Wirecolor.com

the ultimate online tool

Visit wirecolor.com for wiring information and photographs providing detailed installation processes.

Email Sign Up

Get products & corporate
updates with our newsletter.