Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Linker LT1 not starting vehicle

0 votes
Evo one, 2017 sonata reg key, oem and aftermarket remotes working, on the my car app it sees voltage and red and green lights are lit on LT1, I programmed the LT1 to module but it won't start vehicle
asked Oct 16, 2018 in Hyundai by rich soler (560 points)

2 Answers

0 votes
which remotes to you have programmed to the unit?

were you able to properly pair the linkr and evo-one? was option Fortin2 enabled?
answered Oct 16, 2018 by Robb (200,830 points)
AX RF1, I believe it paired as I received a red light at end of sequence, fortin2 is enabled in module, app only has option for fortin
On your antenna what is written? FM or FMH-2way?
fmh 2w, diode installed in harness also
Any troubleshooting for this?
try unplugging the my car then program the fortin remote, then plug it back in and try to program just the my car?
Remotes are axxess rf1,,,they are working....the lt1 pairs, fortin2 is enabled in evo one,,,only choice in my car app is fortin
0 votes
Working, wiring was wrong
answered Oct 20, 2018 by rich soler (560 points)

I have followed the LINKR-LT1 manual to the letter and it has been impossible to run my EVO-ONE with the LINKR-LT1. I have updated the firmware of the EVO-ONE to the latest version and configured the protocol to Fortin 2, I am also configuring the EVO-ONE with the valet buttom, what calls my attention is that when I am configuring the EVO-ONE according to the instructions the LED next to the main button starts flashing repeatedly and does not remain fixed as in the manual instructions. I would appreciate comments about some extra procedure to do troubleshooting. Could you please share the exact wiring that you are using which worked for you?

...