Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Chevrolet Cruze 2013 Push-to-Start + Fortin EVO-ALL

+2 votes
I bought the official website of the device Fortin EVO-ALL and programmer for it. When connecting I have a problem . The problem occurs in the first step when power to the device , namely the black (ground) and the red cable ( +12 ) . I followed the instructions , squeezed the button on the device and connect the power connector ( black connector) . After connecting the flashing LEDs in the following order : blue, yellow, red , yellow , blue + red, and then blue, yellow, red , yellow , blue + red, etc. According to the instruction sequence indicators should flash sequentially. I can not understand what it is, after all only connected power .
Despite this, I continued connection . Follow step 2, 3 , 4 ( the behavior of the indicators consistent with instructions) and step 5 again discrepancy after clicking on the Push-to-Start tanned just two yellow + red LED . What am I doing wrong?
My car Chevrolet Cruze 2013 Push-to-Start.
EVO-ALL Service # 001A06250124
asked Nov 7, 2013 in Chevrolet by Sirik Mikhail

1 Answer

+1 vote
 
Best answer

I bought the official website of the device Fortin EVO-ALL and programmer for it. When connecting I have a problem . The problem occurs in the first step when power to the device , namely the black (ground) and the red cable ( +12 ) . I followed the instructions , squeezed the button on the device and connect the power connector ( black connector) . After connecting the flashing LEDs in the following order : blue, yellow, red , yellow , blue + red, and then blue, yellow, red , yellow , blue + red, etc. According to the instruction sequence indicators should flash sequentially. I can not understand what it is, after all only connected power .

The LED sequence you said is fine, as long as they alternate and do not all flash at the same time you are fine.

 

Follow these steps:

  1. Hold down button while plugging in the datalink, let go when LED is YELLOW
  2. Push the programming button 5 times. Wait until the YELLOW LED turns on solid.
  3. Plug in the rest of the connectors this way: RED connector, 20-Pin white connector5-Pin white connector
  4. Push on the vehicles PTS button and contiue on with the installation.

 

 

 

answered Nov 7, 2013 by Robb (262,210 points)
selected Feb 14, 2014 by Robb

Made on your instructions, but it did not work (((write your e-mail address I will send the video. Do you have another idea?

You can try sending it to support@ifar.ca

Hi Sirik,

It's the same programming as a Buick Regal PTS...

  1. Remove the battery from ONE of the OEM remotes.
  2. Put all other remotes 20 feet away from the vehicule.
  3. Place the OEM remotes in KEY PORT if you have one OR the CUP HOLDER as shown in the installation guide.
  4. When you push the Push-To-Start ignition must turn on.

 

http://www.youtube.com/watch?v=XGw1M_wHHmA

 

Have a nice day

...