Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

hood trigger and constant horn

0 votes
hooked up my evo all.  with hood trigger, valet, and proximity sensor.  I am using my horn as the alarm and hooked up the relay.  everything works fine when triggered.

except when i tested the hood trigger the horn honked once then did a continuous horn.  it would not shut off with any of the buttons on the key.  i had to disconnect the evo-all to shut it off.

i connected the hood pin  to the dk blue trigger.

what could be the issue
closed with the note: Issue: Bad Ground Wire.
asked Jul 2, 2018 in Jeep by david smith (160 points)
closed Jul 5, 2018 by derek !

1 Answer

0 votes
Whats the service number? Check option G1. On is for Horn output (pulsed) , Off is for a siren output (latched)
answered Jul 3, 2018 by Robert T (284,630 points)
have it set correctly.  when the proximity sensor is set off the horn pulses.  Its only the hood trigger that is not working correctly.  just a blaring horn that won't shut off until i disconnect the unit