Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

2018 Subaru Outback Keystart EVO-ALL Solace S3 (IC4) Won't Stay Running

0 votes
Just installed a Solace S3 remote starter (IC4 module w/ relay pack v. FW51) using an EVO-ALL in my 2018 Outback with a standard key start.  Everything went well.  Flashed with 79.45 firmware, did the programming, DCryptor went well also.  Car will lock/unlock/hatch release no problem.  Tach is programmed  via data.

Vehicle will start, run for just a couple seconds and shut off. It will attempt this 3 times.  The remote says that the car is running (I get confirmation as such) but it still dies.... then attemps restart.

I've double checked all wires at ignition. All appears good. Any ideas?
asked Feb 11, 2018 in Subaru by tjamz0061 (340 points)

1 Answer

0 votes
Turns out the instructions were wrong. The blue/black immobilizer wire needs to go on the plug side of the cut (Yellow/Red), not the vehicle side (Yellow/Green) as depicted in the diagram. Big shout out to Solace for their after hours support on their Facebook page!
answered Feb 12, 2018 by tjamz0061 (340 points)
edited Feb 12, 2018 by tjamz0061
...