Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

question on lock/arm and unlock/disarm wiring

0 votes
Can you clarify in the wiring schematic for lock/arm and unlock/disarm wires inside the door panel of 2012 QX56 (reference guide #33191). From reading the schematic, I'm assuming I cut the Lock/Arm wire inside the door panel and then tie the cut wire to the A2/A5 wires. I would then do the same for Unlock/Disarm wire inside the door and tie to the A3/A4 wires. The question is what side of the cut wire(s) do I tie the wires coming from the T-harness ?
asked Feb 7, 2018 in Infiniti by CRB (190 points)
edited Feb 7, 2018 by CRB

1 Answer

0 votes
it's an EVO-ONE right?

Just use the purple and purple/white evo-one outputs for doorlock control. No need to cut anything.

The only reason it is said to cut the green and white wires is if you would need those little connectors on the tip of the wires. Which you dont in this vehicle.
answered Feb 7, 2018 by Robb (232,460 points)
Correct it is an EVO-One unit. So the "cut not connected" was referring to the green (A4) and white (A5) wires from the T-harness and not referencing cutting the lock/arm and unlock/disarm wires located in the infiniti driver side door?

Based on your comments, I would splice the purple (A2) wire from the t harness into the lock/arm wire (red wire) located in the infiniti driver door and splice the purple/white (A3) wire from the t harness into the unlock/disarm wire (green wire). Is this correct?
...