Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

2014 F150 - ignition stays on after removing key at end of programming

0 votes
OMEVOALL with THAR-FORD1 harness. EMEVOFORT preloaded.  Hardware date 12/2017.

Module is not programming correctly.

Blue and red lights come on.

First key goes in. Blue, red lights on.

First key out. Blue and red

Second key in. Blue, red, yellow lights on.

When second key comes out, the ignition thinks the key is still in and on the "on" positon (blower and dash lights are one even after key out). Dash says, "Factory Keypad 11359." However, the car doesn't have a keyless entry key pad. All electronics are stock. No aftermarket options. When the second key comes out, the, back to just blue and red lights.

First key goes back in. Lights flash ten times. Then blue light. Then none. Key comes out. ingition behavior back to normal. Remotes work normally. No lights on EVO. No remote start functionality when pressing lock 3x.

Please advise.
asked Jan 28, 2018 in Ford by Jim Stephens (130 points)

1 Answer

0 votes
try the programming without the RED connector connected. Once programmed, reconnect the red connector.

 

The module is also flashed for a Ford Edge: https://fortin.ca/en/support/003606013368/

Not sure if used or not so you may need to do a reset on the module. https://cdn.fortin.ca/en/download/61931/61931.pdf
answered Jan 29, 2018 by Robb (216,200 points)
...